Previous: Terminal Mode Commands, Up: Terminal Mode Operation [Contents]
Display part parameters, modify eeprom cells, perform a chip erase:
% avrdude -p m128 -c stk500 -t
avrdude: AVR device initialized and ready to accept instructions
avrdude: Device signature = 0x1e9702
avrdude: current erase-rewrite cycle count is 52 (if being tracked)
avrdude> part
>>> part
AVR Part : ATMEGA128
Chip Erase delay : 9000 us
PAGEL : PD7
BS2 : PA0
RESET disposition : dedicated
RETRY pulse : SCK
serial program mode : yes
parallel program mode : yes
Memory Detail :
Page Polled
Memory Type Paged Size Size #Pages MinW MaxW ReadBack
----------- ------ ------ ---- ------ ----- ----- ---------
eeprom no 4096 8 0 9000 9000 0xff 0xff
flash yes 131072 256 512 4500 9000 0xff 0x00
lfuse no 1 0 0 0 0 0x00 0x00
hfuse no 1 0 0 0 0 0x00 0x00
efuse no 1 0 0 0 0 0x00 0x00
lock no 1 0 0 0 0 0x00 0x00
calibration no 1 0 0 0 0 0x00 0x00
signature no 3 0 0 0 0 0x00 0x00
avrdude> dump eeprom 0 16
>>> dump eeprom 0 16
0000 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff |................|
avrdude> write eeprom 0 1 2 3 4
>>> write eeprom 0 1 2 3 4
avrdude> dump eeprom 0 16
>>> dump eeprom 0 16
0000 01 02 03 04 ff ff ff ff ff ff ff ff ff ff ff ff |................|
avrdude> erase
>>> erase
avrdude: erasing chip
avrdude> dump eeprom 0 16
>>> dump eeprom 0 16
0000 ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff |................|
avrdude>
|
Program the fuse bits of an ATmega128 (disable M103 compatibility, enable high speed external crystal, enable brown-out detection, slowly rising power). Note since we are working with fuse bits the -u (unsafe) option is specified, which allows you to modify the fuse bits. First display the factory defaults, then reprogram:
% avrdude -p m128 -u -c stk500 -t avrdude: AVR device initialized and ready to accept instructions avrdude: Device signature = 0x1e9702 avrdude: current erase-rewrite cycle count is 52 (if being tracked) avrdude> d efuse >>> d efuse 0000 fd |. | avrdude> d hfuse >>> d hfuse 0000 99 |. | avrdude> d lfuse >>> d lfuse 0000 e1 |. | avrdude> w efuse 0 0xff >>> w efuse 0 0xff avrdude> w hfuse 0 0x89 >>> w hfuse 0 0x89 avrdude> w lfuse 0 0x2f >>> w lfuse 0 0x2f avrdude> |
Previous: Terminal Mode Commands, Up: Terminal Mode Operation [Contents]